697203 - Timer Kit - Electromechanical 120 Min w/Hold, with Knob and Hardware - Threaded Bushing Mount

697203 - Timer Kit - Electromechanical 120 Min w/Hold, with Knob and Hardware - Threaded Bushing MountTimer Kit Electromechanical 120 Min w Hold, with Knob and Hardware Threaded Bushing Mount This timer kit contains components necessary to replace obsolete electromechanical timers in many older battery chargers. The included dial labels are particularly helpful in retrofit applications for example, replacing a 90 minute timer. Note that these installations are not direct boltin replacements. Some modification of the charger cabinet may be necessary

Timer Kit - Electromechanical 120 Min w/Hold, with Knob and Hardware - Threaded Bushing Mount

This timer kit contains components necessary to replace obsolete electromechanical timers in many older battery chargers. The included dial labels are particularly helpful in retrofit applications – for example, replacing a 90-minute timer.

Note that these installations are not direct “bolt‑in” replacements. Some modification of the charger cabinet may be necessary (e.g.- drilling holes), as well as a basic electrical knowledge and skill level.

Basic electrical tools are necessary. A multi‑meter may also be required.

This switch typically mounts in one of two orientations:

Horizontal Mount - the anti-rotation pin is aligned below the knob stem (at 6 o'clock) and the OFF position is at approximately 2 o'clock on the timer dial face.

Vertical Mount - the anti-rotation pin is aligned to the right of the knob stem (at 3 o'clock) and the OFF position is at approximately 11 o'clock on the timer dial face.

In either orientation, the timer has a "HOLD" position (constant ON) when rotated counterclockwise from OFF by approximately 15 degrees. Otherwise, when rotated clockwise to a set position, it will countdown back to the OFF position and power off the charger.

Features

- 120 Minute duration, with "HOLD" position.
- Mounts in charger panel with included panel nut and lock washer.
- Straightforward instructions and simple design allows easy installation. No special tools are required, though drilling may be necessary.
- Made in the USA

Specifications

- .250" Push-on connectors
- Switched Current Rating - 15A, 125/250VAC, 50/60HZ
- Timer body - 2.476"H x 2.01"W x 1.969"D
- Stem - .815"L x .248" Diameter

Contents

1 - 697201, 120-minute electromechanical timer with panel nut and lock washer
1 - 696550, spring clip pointer knob (EXACT OEM replacement for Associated 603147)
1 - 609063, timer dial label - horizontal mount
1 - 609064, timer dial label - vertical mount
1 - Installation Instructions

Information Downloads

697203 Installation Instructions