
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 8 - Jul 13
For Your Every Summer RSVP, with Code: SUMMER15
Description
6.56-Inch 12-1x Crank Trigger Wheel For Gen III and IV LS6. 56 Inch 12 1x Crank Trigger Wheel For Gen III and IV LS Overview Upgrading to an MSD Flying Magnet Crank Trigger Kit will deliver the precise and reliable signal that a high performance engine requires. This kit gives you the ability to control timing electronically through a Holley EFI ECU (or other standalone engine management system ignition controller). At the heart of the kit is the 3 wire Hall Effect Sensor that is easier to set up, less
6.56-Inch 12-1x Crank Trigger WheelFor Gen III and IV LS
Overview
Upgrading to an MSD Flying Magnet Crank Trigger Kit will deliver the precise and reliable signal that a high performance engine requires. This kit gives you the ability to control timing electronically through a Holley EFI ECU (or other standalone engine management system / ignition controller). At the heart of the kit is the 3-wire Hall-Effect Sensor that is easier to set up, less susceptible to EMI/RFI interference/noise, and less likely to have false signals than other methods (Distributors and VR Magnetic Sensors). In addition, they are less prone to mechanical failure since there are no wear parts. With the included high quality timing pointer and the use of a direct bolt-on, degreed balancer (see below list for recommendations), you'll be able to adjust timing in the precise increments required for your engine. Coyote 556-173 We recommend using ATI 918047-MSD but will also work with 918047N and 918047NA LS 8 inch 556-174 Designed to work directly with ATI 917302, 918852, 917264 or 917242 LS 7.28 inch 556-175 Designed to work directly with ATI 917777, 917211 or 917234 LS 6.56 inch 556-176 Designed to work directly with ATI 917776 or 917215
Features:
- Most accurate way to trigger your electronic fuel injection (EFI), can be installed as 12-1 or 12x
- Powerful magnets embedded in a 3/8-inch thick billet 6061-T6 aluminum trigger wheel
- 3-wire Hall-Effect Sensor that is not easily susceptible to EMI/RFI Interference
- Engine specific kits include a direct bolt-on billet aluminum pick up bracket
- Rigid mounting that will not flex and cause timing fluctuation
- Easy to install much like traditional MSD Crank Trigger Kits
- Included installation instructions cover mechanical setup and provide step-by-step Holley EFI Software Setup
Details:
- Color: Silver
- Diameter: 6.56-inch
- Make: Gen III and IV LS
- Sensor Type: Hall Effect
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 156 reviews
Sort
Product Reviews
★★★★★ 5
Recommended
Size: (Pack of 1)
This Wix air filter was a perfect fit for my vehicle and a great quality product. I highly recommend this Wix cabin air filter to anyone looking for a reliable and effective replacement.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 4, 2024
★★★★★ 5
Much thicker filter (more surface area), should filter better
Size: (Pack of 1), Size: (Pack of 1)
First filter change at about 28000 miles. Original filter was pretty dirty but OK on intake side.
WIX filter is quite a bit thicker but fits my 2016 RAM 5.7L Hemi fine. Also cleaned out the bottom side of the air filter box.
The WIX filter is much cheaper than the Mopar and seems to have a similar construction but is much thicker. Assuming the filter media is the same, the WIX should in theory filter and breathe better (more surface area) - but I am no expert so.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 14, 2021
★★★★★ 5
Good quality.
Size: 15"+15"+13"
I needed to replace the wiper blades on my Jeep Wrangler JK, so I first went to a local auto parts store. The prices were pretty expensive, and they didn’t even have the correct replacement for my rear wiper blade.
That’s when I decided to order the UTOBOO 15"+15" Windshield Wipers with 13 Inch Rear Wiper Blade Replacement online, and I’m really glad I did.
The set arrived quickly and included everything I needed for both the front and rear wipers. Installation was very easy and only took a few minutes. They fit well on my Jeep, and the blades feel sturdy and made from good-quality materials.
After using them, they wipe smoothly and leave the windshield clean without streaks, which is exactly what you want, especially in rain or dusty conditions.
Overall, this is a great value compared to buying individual blades in-store, and it’s especially convenient since it includes the rear wiper replacement too. I would definitely recommend these to other Jeep Wrangler owners looking for an affordable and reliable option.
------Tip, don't forget to take off the green plastic, If you check the comments many people argues that the wipers don't work but in the pictures you can see they did not take off the green plastic protector. ----
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 12, 2026
★★★★★ 5
Love
Size: 26+20+14"
I recently purchased the AUTOBOO 26” + 20” windshield wipers with the 14” rear blade, and I’m honestly very happy with them. Installation was quick and straightforward, even without much experience changing wipers. They fit perfectly on my car and clicked into place securely.
The wiping performance is smooth and quiet, with no streaks or squeaking, even during heavy rain. I also noticed they clear water evenly across the windshield, which makes driving feel much safer, especially at night or on the highway.
The rear 14” blade works just as well and was a nice bonus since it’s sometimes harder to find a good rear wiper included in a set.
Overall, this set offers great value for the price, and I would definitely buy them again and recommend them to anyone looking for reliable, easy-to-install windshield wipers.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 22, 2026
★★★★★ 5
Decent wipers for a great price
Size: 28+28+11
These fit my daughters Ford Escape perfectly and the day after installation, it rained. The wipers work really well and the windshield is now streak free once again and the price was right. Easy to change and look good.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 6, 2026